Allied Telesis AT-S65 - Manual (Page 24)

Chapter 2: Basic Parameters
24
Note
The IP Address, Subnet Mask, and Default Gateway parameters are
described in “Configuring the IP Address, Subnet Mask, and Default
Gateway,” next. The Manager IP addresses are described in
“Configuring the Manager IP Addresses” on page 24. The Disable
DHCP and Enable DHCP parameters are described in “Enabling or
Disabling DHCP” on page 25.
Configuring the
IP Address,
Subnet Mask, and
Default Gateway
To configure parameters for managing the chassis remotely, perform the
following procedure:
1. From the Main Menu, select System Configuration.
The System Configuration Menu is shown in Figure 4 on page 22.
2. From the System Configuration Menu, select IP Parameters and
press Enter.
The IP Parameters Menu is shown in Figure 5 on page 23.
3. Adjust the following parameters as necessary:
IP Address
Specifies the IP address of the chassis. You must specify an IP
address, subnet mask, and gateway address if you intend to use
Telnet or an SNMP management application to manage the chassis
remotely. In addition, if the management station is separated from the
chassis by a router, you must also provide a gateway address, which
is the IP address of a router through which the chassis can
communicate with the remote management station.
Subnet Mask
The subnet mask for the chassis. You must assign a subnet mask to
manage the chassis remotely.
Gateway Address
The IP address of the default router. You must assign a subnet mask
to manage the chassis remotely if a router separates the management
station from the chassis.
4. After you have adjusted the parameters, return to the Main Menu.
Configuring the
Manager IP
Addresses
You can specify up to four network management stations that will receive
SNMP traps from the system.
To configure the manager IP addresses, perform the following procedure:
1. From the Main Menu, select System Configuration.