Allied Telesis AT-S65 - Manual (Page 55)

AT-S65 Management Software User’s Guide
55
The Activity Monitor is shown in Figure 25.
Figure 25. Activity Monitor
The activity monitor continues to display system activities until you
press Enter to return to the previous menu and select Stop Log.
The activity log messages are described in Table 3. The messages
shown in the activity log are the same as those shown in the event log
described in “Using the Event Log” on page 57. Each message is
preceded either by “REPORT” or “CLEAR.” REPORT indicates that an
error is being reported, and CLEAR indicates that the error has been
cleared. The “n” in the message indicates the number of the line card,
fan module, and so forth where the event occurred.
Activity Monitor
(Press Return to resume the previous menu)
04:26:17 0:04:42:01:CLEAR:Line Card 3 Wavelength Mismatch
04:26:17 0:04:42:01:REPORT:Line Card 3 Missing
04:26:17 0:04:42:01:REPORT:Line Card 3 Wavelength Mismatch
04:26:17 0:04:42:01:CLEAR:Line Card 3 Missing
04:26:17 0:04:42:01:REPORT:Line Card 3 SFP Link Down
04:26:17 0:04:42:01:REPORT:Line Card 3 RX Synchronization Failed
04:26:17 0:04:42:01:REPORT:Line Card 3 SFP Transceiver is Disabled
Table 3. Activity and Event Log Events
Event Description
Chassis Temperature Exceed High Limit The chassis temperature has exceeded the
set maximum limit.
Fan Module n Failed A chassis fan has failed.
Line Card n Missing The line card is missing from the slot.
Line Card n RX Synchronization Failed The line card’s receive port synchronization
has failed.
Line Card n SFP Link Down The receive port on the SFP has a loss of
signal.
Line Card n SFP Port Shutdown The SFP port has been shut down.
Line Card n SFP Rate Changed The line card rate has changed.
Line Card n SFP Temperature Exceed High Limit The temperature of the SFP has exceeded
the set maximum temperature.