Allied Telesis AT-S105 - Manual (Page 74)

Chapter 5: Port Configuration
74
Flow Control
The current flow control setting on the port. The switch uses a special
pause packet to notify the end node to stop transmitting for a specified
period of time. The possible values are:
Ignore - Indicates the All setting does not apply to the Flow Control
field. In other words, each port is set individually.
Enabled - The port is permitted to use flow control. This is the
default setting for all ports on the switch.
Disabled - The port is not permitted to use flow control.
EAP Pass
Extensible Authentication Protocol (EAP) packets are allowed on the
port.
Ignore - Indicates the All setting does not apply to the Admin.
Status field. In other words, each port is set individually.
Enabled - The port is able to send and receive EAP packets.
Disabled - The port is disabled and is not able to send or receive
EAP packets. This is the default setting for a port.
3. Click Apply to save the configuration.
4. From the main menu on the left side of the page, select Save
Configuration to Flash to permanently save your changes.