Allied Telesis AT-S105 User Manual
Page 44
Chapter 2: Basic Switch Parameters
44
Returning the AT-S105 Management Software to the Factory Default
Values
This procedure returns all AT-S105 Management software parameters to
their default values and deletes all tagged and port-based VLANs on the
switch. The AT-S105 Management software Management Software
default values are listed in Appendix A, on page 221.
Caution
This procedure causes the switch to reboot. The switch does not
forward network traffic during the reboot process. Some network
traffic may be lost.
To return the AT-S105 Management software software to the default
settings, do the following procedure:
1. From the Tools folder, select Reboot.
The Reboot Page is shown in Figure 13 on page 40.
2. For the Reboot Type field, use the pull-down menu to select one of
the following:
Factory Default
Resets all switch parameters to the factory default settings, including
the IP address, subnet mask, and gateway address.
Warning
This setting will cause the IP address to be reset to 192.168.1.1.
You will loose connectivity with the switch management software
after the reboot is completed
Factory Default Except IP Address
Resets all switch parameters to the factory default settings, but retains
the IP address, subnet mask, and gateway settings. If the DHCP client
is enabled, it remains enabled after this reset.
3. For the Reboot Status field, use the pull-down menu to select Start to
begin the reboot.
4. Click Apply.
The switch is rebooted. You must wait for the switch to complete the
reboot process before establishing your management session again.