Allied Telesis AT-S105 - Manual (Page 194)

Chapter 18: Power over Ethernet (PoE)
194
Setting Power over Ethernet
This procedure explains how to set the POE feature on the
AT-FS750/24POE switch.
To set the POE feature, do the following procedure:
1. From the main menu on the left side of the page, select the Power
Over Ethernet Page.
The Power Over Ethernet Configuration Page is displayed. See Figure
61.
Figure 61. Power Over Ethernet Configuration Page
2. To change the setting of the Admin field, select the pull-down menu
next to ports 1 through 4. Choose from the following options:
Up
Indicates the PoE port is available to be connected to a powered
device. This is the default setting.
Down
Indicates the PoE port is not available to be connected to a powered
device.