Allied Telesis AT-GS950/24 - Manual (Page 91)

AT-GS950/24 Web Interface User Guide
91
Generic MSTP Port Settings
To configure the generic MSTP parameters for each of the ports, perform
the following procedure:
1. From the main menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select the Spanning Tree folder.
The Spanning Tree folder expands.
3. From the Spanning Tree folder, select Port Settings.
The Port Settings Page is displayed. See Figure 31 for a partial view of
this page.
Figure 31. Port Settings Page
You may choose a port and configure its MSTP parameters on this
page. The following information is displayed:
Port - Indicates the port numbers on the AT-GS950/24 switch. You
can select the All row to apply the same setting to all ports of your
switch.
STP Status - Specifies if MSTP is Enabled or Disabled.
Enabled - MSTP is active on the port.
Disabled - MSTP is inactive on the port.
Priority - Specifies the spanning tree port priority.
Admin Cost - Specifies the cost of a port to the root.
External Cost - Indicates the operating cost of a port connected to
a device outside its region.
State - Indicates one of the following port states: