Allied Telesis AT-GS950/24 - Manual (Page 338)

Chapter 25: Software/Configuration Updates
338
Figure 135. Firmware Upgrade via TFTP Page
The Image Version shows the current version and date of software
installed on the switch.
3. Change the following parameters as necessary:
TFTP Server IP: The IP address of the TFTP server from which
you are downloading the new software:
For an IPv4 address, click IPv4, then enter the address using
xxx.xxx.xxx.xxx format.
For an IPv6 address, click IPv6, then enter the address using
xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx hexadecimal format.
Image File Name: The full name of the AT-S115 file (including the
file extension) you are downloading.
Retry Count: The number of times the firmware upgrade is retried.
The range is 1 - 20.
4. To activate your changes on the switch, click Apply.
The software immediately begins to download onto the switch. This
process takes a few minutes. After the software download is complete,
the switch initializes the software and reboots. You will lose your web
browser connection to the switch during the reboot process.