Allied Telesis AT-GS950/24 - Manual (Page 282)

Chapter 21: Security
282
TACACS+: This parameter configures port security for
TACACS+ authentication. After completing Step 4 through
Step 6, you must configure the “TACACS+” on page 289.
Local: This parameter configures port security for local
authentication. After completing Step 4 through Step 6, you
must configure the parameters for “Dial-in User— Local
Authentication” on page 292.
4. Click Apply when you are finished configuring the parameters.
5. To set the advanced configuration parameters, click Settings.
The Port Access Control Settings page is expanded. See Figure 113.
Figure 113. Expanded Port Access Control Settings Page
6. Set the following parameters as needed:
Port: This parameter specifies the port being configured for
authentication.
Authentication Mode: This parameter specifies the port-based
authentication mode. The pull-down menu choices are as follows:
802.1x: 802.1x is specified as the authentication mode. This
setting applies to configuration for RADIUS, TACACS+, or Dial-