Allied Telesis AT-GS950/24 - Manual (Page 226)

Chapter 17: SNMPv3
226
In addition, you can define an MIB view that the user can access or an
MIB view that the user cannot access. When you want to permit a user to
access an MIB view, you include a particular view. When you want to deny
a user access to an MIB view, you exclude a particular view.
After you specify an MIB subtree view you have the option of further
restricting a view by defining a subtree mask. The relationship between an
MIB subtree view and a subtree mask is analogous to the relationship
between an IP address and a subnet mask. The switch uses the subnet
mask to determine which portion of an IP address represents the network
address and which portion represents the node address. In a similar way,
the subtree mask further refines the subtree view and enables you to
restrict an MIB view to a specific row of the OID MIB table. You need a
thorough understanding of the OID MIB table to define a subtree mask.
SNMPv3
Configuration
Process
The SNMPv3 parameters are contained in the following tables for user
configuration:
 SNMPv3 User/Group table
 SNMPv3 Access table
 SNMPv3 View table
 SNMPv3 Community table
 Trap Management
The SNMPv3 configuration information must be entered in a specific
sequence:
Note
The SNMP Interface must be activated first. See “User Interface
Configuration” on page 45.
1. You create a User Name and associated Group Name in the SNMPv3
User/Group table.
2. The View Names are defined in the Access table for each Group
Name.
3. The MIB view is then defined in the SNMPv3 View table for each View
Name.
4. You must enter information in the Community table based on a pre-
defined User Name.
Note
The Community Strings do not have a default value defined and are
initially blank.