Allied Telesis AT-GS950/24 - Manual (Page 132)

Chapter 10: MAC Address Table
132
Static Unicast MAC Address Configuration
This procedure explains how to set the static unicast feature for each port
on the AT-GS950/24 switch. Before beginning this procedure, you must
create either an 802.1Q VLAN ID or a Port-Based VLAN Index. For
information about defining these parameters, see:
 “Tagged VLAN Configuration” on page 166 regarding the 802.1Q
VLAN parameter.
 “Port-Based VLAN Configuration” on page 173 regarding the Port-
Based VLAN parameter.
To add a static MAC address to the switch, perform the following
procedure:
1. From the main menu on the left side of the page, select the Bridge
folder.
The Bridge folder expands.
2. From the Bridge folder, select Static Unicast.
The Static Unicast Address Table Page is displayed. See Figure 43.
Figure 43. AT-GS950/24 Static Unicast Address Table Page
3. Select either the 802.1Q VLAN or Port-Based VLAN radio button and
enter the respective VLAN ID (1-4093) or VLAN Index (1 - 52).