beautypg.com

Egress rate limiting – Allied Telesis AT-GS950/24 User Manual

Page 156

background image

Chapter 12: Storm Control

156

Egress Rate Limiting

This procedure explains how to set Bandwidth levels and Status for
Egress Rate Limiting on each port of the AT-GS950/24 switch.

To change the settings of the egress rate limiting feature, perform the
following procedure:

1. From the main menu on the left side of the page, select the Bridge

folder.

2. From the Bridge folder, select Bandwidth Control.

The Bandwidth Control folder expands.

3. From the Bandwidth Control folder, select Egress Rate Limiting.

The AT-GS950/24 Egress Rate Limiting page is displayed. See Figure
55 for a
partial view of this page.

Figure 55. AT-GS950/24 Egress Rate Limiting Page

To set the Bandwidth field, enter a number in the range of 1 to 15625.
You can select the All row to set all of the ports to the same setting.

Note
See “Egress Rate Limiting” on page 151 for calculating the
bandwidth limit set by the Bandwidth field.

4. To enable or disable the egress rate filter, select Enable or Disable

from the Status pull-down menu next to the port that you want to
change. You can select the All row to set all of the ports to the same
setting.
The Ignore parameter indicates that the setting in the All row does not
apply to the Status menu for individual ports.

5. Click Apply.

6. From the main menu on the left side of the page, select Save Settings

to Flash to permanently save your changes.