Allied Telesis AT-GS950/24 - Manual (Page 177)

AT-GS950/24 Web Interface User Guide
177
View Dynamic Forwarding Table
You can view the MAC addresses the switch has stored in the forwarding
table. You can view all of the addresses in the table or only the addresses
learned on a particular port.
To view the MAC address forwarding table, perform the following
procedure:
1. From the main menu on the left side of the page, select Bridge.
The Bridge folder expands.
2. From the Bridge folder, select VLAN.
The VLAN folder expands.
3. From the VLAN folder, select Dynamic Forwarding Table.
The Dynamic Forwarding Table Page is shown in Figure 65.
Figure 65. Dynamic Forwarding Table Page
4. To view all MAC addresses, select All from the Port drop-down menu.
To view MAC addresses for a particular port, select the port from the
Port drop-down menu.
Note
Ports without a “p” before the number indicate switch ports. Ports
with a “p” before the number indicate port trunks. For example, 02
would indicate switch port 2, and po2 would indicate port trunk 2.
The Dynamic Forwarding Table Page displays the following:
ID - ID number of recorded entry in database.
VID - ID number of the VLAN where the port is a member.
Port - Port or port trunk where the address was learned by the
switch.