Allied Telesis AT-GS950/24 - Manual (Page 33)

AT-GS950/24 Web Interface User Guide
33
System Subnet Mask - Displays the current subnet mask of the
switch. To change the subnet mask, enter a new subnet mask.
When DHCP is enabled, you cannot change this parameter.
System Default Gateway - Displays the default gateway of the
switch. To change the default gateway, enter a new gateway.
When DHCP is enabled, you cannot change this parameter.
System IP Mode - Displays the current mode of the switch. To
change the mode, select Static, DHCP, or BootP. If the DHCP or
BootP mode is selected, you cannot change the System IP
Address, System Subnet Mask, and System Default Gateway
parameters because these parameters are automatically retrieved
by the DHCP or BootP server. For information about setting the
DHCP mode, refer to “DHCP Client Configuration” on page 53.
4. Click Apply.
Note
Changing the IP address ends your management session. To
resume managing the device, enter the new IP address of the switch
in the web browser’s URL field, as shown in Figure 1 on page 24.
5. After you log on to the switch with the new IP address, select Save
Settings to Flash from the main menu on the left side of the page to
save the new IP address to memory.
Caution
If you do not select Save Settings to Flash, the IP address will
revert to its original setting when you power cycle or reboot the
switch.