Allied Telesis AT-GS950/24 - Manual (Page 154)

Chapter 12: Storm Control
154
Ingress Rate Limiting
This procedure explains how to set Bandwidth levels and Status for
Ingress Rate Limiting on each port of the AT-GS950/24 switch.
To change the settings of the ingress rate limiting feature, perform the
following procedure:
1. From the main menu on the left side of the page, select the Bridge
folder.
2. From the Bridge folder, select Bandwidth Control.
The Bandwidth Control folder expands.
3. From the Bandwidth Control folder, select Ingress Rate Limiting.
The AT-GS950/24 Ingress Rate Limiting page is displayed. See Figure
54 for a partial view of this page.
.
Figure 54. AT-GS950/24 Ingress Rate Limiting Page
4. To set the Bandwidth field on the AT-GS950/24 switch, enter a
number in the range from 1 to 15625.
Note
Refer to “Ingress Rate Limiting” on page 151 for calculating the
bandwidth limit set by the Bandwidth field.
You can select the All row to set all of the ports to the same setting.