Horner APG RCS SmartStix - Manual (Page 49)

CH.5 15 MAR 2003 PAGE 49
MAN0305-04
CHAPTER 5: MINI CONFIGURATION
5.1
General
Chapter Five provides preliminary configuration procedures that are applicable to all MiniOCS / MiniRCS
models.
Remote Screen Usage for the the MiniRCS: The MiniRCS has the same functionality as the MiniOCS
except that it does not have a local operator screen and keypad. However, the MiniRCS supports a
remote operator screen and keypad. through a PC connected to the Mini unit’s built-in network. If
desired, the remote operator interface and keypad can be displayed (using Cscape software) by pressing
Screens, Remote Text Terminal. A virtual display screen and keypad appears that is similar to that of
the MiniOCS. In addition, a Status Bar can be used as a tool to ensure that communications are properly
established. For more information on the Remote Test Terminal and the Status Bar feature, se e
page 45.
Note: The examples in this chapter depict the MiniOCS, but the information also applies to the
MiniRCS when using the Remote Text Terminal screen.
The MiniOCS / MiniRCS models use Cscape Software for configuration. General information is also
provided pertaining to the screens that the user encounters when configuring specific modules. In
addition, each MiniOCS / MiniRCS model has its own data sheet which covers specifications, wiring and
other pertinent information. (See page 18.)
5.2
Preliminary Configuration Procedures
1. The MiniOCS / MiniRCS configuration is accomplished through the Configure Controller Type Dialog.
Note: The configuration examples in this chapter depict the MiniOCS, but the procedures also apply to
the MiniRCS as well.
a.
Using Auto Configuration
From the Main Menu, select Controller|Configure for the following dialog. If the desired MiniOCS /
MiniRCS is physically connected to the PC, press Auto Config. A dialog box appears and indicates that
settings will be deleted from currently configured models. If OK, press Yes. Then press OK.
To obtain a description of the MiniOCS / MiniRCS model, double-click on the box (or press the top
Config button) to select the desired controller from the pull-down menu.