Horner APG RCS SmartStix - Manual (Page 41)

CH.3 15 MAR 2003 PAGE 41
MAN0305-04
•
View OCS(RCS) Diags
This screen displays a list of self-test diagnostics results (no editable fields). Each item describes a test
and shows a result of Ok if the test passed or Fault/Warn if an error was found while running the test.
Fault indications will prevent the loaded application from running. Warn(ing) indications allow the
application to run but inform the user that a condition exists that needs correction.
System BIOS - This test checks for a valid BIOS portion of the controller firmware.
Ok The loaded BIOS firmware is valid
Fault The loaded BIOS is invalid.
(Engine) Firmware - This test validates the controller firmware.
Ok The firmware is valid.
Fault The controller firmware is invalid.
User Program - This tests for a valid user program and configuration data.
Ok The user program and configuration is valid.
Fault The user program and/or configuration are not valid.
System RAM - This test checks the functionality of the controller RAM at power up.
Ok The RAM is functioning correctly.
Fault The RAM is not functioning correctly.
Logic Error - This test checks for problems with the user program while running.
Ok No errors have been encountered while running a user program.
Fault Indicates the user program contained an instruction that was invalid or unsupported.
W-Dog Trips - This test checks for resets caused by hardware faults, power brownouts or large amounts
of electrical interference.
0 No unintentional resets have occurred.
xx Indicates a fault with xx showing the number of occurrences.
Net Errors -
This test checks for abnormal network operations while running. (Network models only.)
0 No network errors were counted
xx Indicate serious networking problems exist, xx indicates the number of occurrences.
Network State - This test checks that the network sub-system is powered and operating correctly.
(Network models only.)
Ok The network system is receiving power and has determined other devices are
communicating on the network.
Warn Power is not being applied to the network or no other devices were found to be
communicating on the network.
Network ID -
This test checks that the network ID is valid. (Network models only.)
Ok The network ID is valid.
Warn The network ID is not valid for the selected protocol.
Dup Net ID - This test checks for duplicate IDs on a network. (Network models only.)
Ok This controller's ID was not found to be a duplicate.
Warn Another controller on the network was found with the same ID as this controller.