Red Lion MDC User Manual
Page 29
FACTORY SETTINGS
MASTER MODE:
FOLLOWER MODE:
USER SETPOINTS:
USER SETPOINTS:
S1
500
S1
1.0000
S2
1000
S2
0.5000
R1
100
R1
0.1000
R2
200
R2
0.2000
DISPLAY 1
DISPLAY 1
LINE 1
SPD-MNE
LINE 1
SPD-MNE
LINE 2
SPD-VAL
LINE 2
SPD-VAL
DISPLAY 2
DISPLAY 2
LINE 1
OP STAT
LINE 1
OP-STAT
LINE 2
SPD- VAL
LINE 2
SPD-VAL
DISPLAY 3
DISPLAY 3
LINE 1
AL STAT
LINE 1
LDHZ-VAL
LINE 2
SPD -VAL
LINE 2
FBHZ-VAL
DISPLAY 4
DISPLAY 4
LINE 1
TRIM-VAL
LINE 1
TRIM-VAL
LINE 2
SPD -VAL
LINE 2
SPD-VAL
SCALING:
PPR LD
60
MAX RPM LD
1750
-27-
USER SETTINGS
This Menu should only be entered if the operator wants to reset ALL
parameters in either Master or Follower mode to the factory settings. If the
MDC is in Master Mode when the word “FACTORY” is flashing in the
display and the ENT key is pressed, all parameters for that mode are reset to
the factory settings upon exiting the Programming Module. The same is true
for Follower Mode. Parameters common to both Master and Follower modes
are reset regardless of the operating mode. The operator can exit the factory
settings option WITHOUT resetting all parameters by pressing the key. The following are the settings when shipped from the factory, along with a chart for user settings: Caution: If factory settings are selected, all programming by the user for that operating mode will be reset. FACTORY SETTINGS COMMON TO MASTER AND FOLLOWER MODES: USER SETPOINTS: OPTIONS: JOG SPD 200 Operator Access: JOG RAMP 50 S1 YES AL-1 1200 S2 YES AL-2 100 R1 YES GAIN 99 R2 YES JOG SPD YES SCALING: JOG RAMP YES PPR FB 60 AL-1 YES MAX RPM FB 1750 AL-2 YES DSP DP 0 GAIN YES DSP UNIT 1750 SPT SCROLL YES USER INPUTS: No Feedback Detection: YES User Input 1 NO MODE User Input 2 NO MODE User Input 3 NO MODE User Input 4 NO MODE User Key F1 RUN User Key F2 R-STOP ALARM OUTPUTS: ALARM 1: Alarm Type HIGH ALM Phase + PHASE Latched/Boundary BOUNDARY Update NORM UPD ALARM 2: Alarm Type LOW ALM Phase + PHASE Latched/Boundary BOUNDARY Update NORM UPD Stop Mode Status STP DSBL DISPLAY: Scroll Speed NONE