Ag Leader SMS Mobile User Manual - Manual (Page 12)

SMS Mobile User Manual
 Default Logging Color - This is the default color that will be used when
logging/creating data that does not currently have a legend attribute set and
or the values being logged/created don't match any legend range values that
you might have currently set.
 Logging 1 Tab
 Logging Interval - Allows the selection of a logging interval from a fixed
list ranging from 10 times per second to once every 60 seconds . This
setting only affects the logging in the Coverage logging Mode. The
logging interval in other operating modes is based on a logging interval
distance set on the Logging 2 Tab and the mapping update rate set on the
Map Display Tab.
 Min Travel Distance - This distance is the minimum distance that must be
traveled before a point will be logged in the Coverage Mode in
conjunction with the logging interval.
 Default Swath Width - This is the default swath width that will be used in
the Coverage Logging mode.
 Coverage Overlap Level - This option regulates the performance of the
Virtual Implement Switch (VIS) in the coverage logging mode. Three
options are provided: Average Overlap, Minimum Overlap, and Maximum
Overlap.
 Logging 2 Tab
 Default Observation Diameter - This is the default diameter that will be used
to create an observation region when you select the Add Region button when
the Start Scouting tool is running. This only applies to the Scouting Mode.
 Auto Close Polygons by Distance - This option when selected will stop the
creation or logging of a new polygon or line if you drive or draw into the set
radius of the start point of the object. The radius distance can be set as well.
This option only applies to operating modes that provide polygon or line
creation tools.
 Polygon/Line Logging Interval - This option defines one of the parameters
used to control when vertices will be logged for a polygon or line. In
conjunction with the map redraw rate, as long as you have traveled the
distance selected with this option a vertex will be logged. Because of these
logging parameters, you will NOT be guaranteed to get a vertex every X
distance that was selected but it will be close.
 Navigation Tab
 Compass Radius - This distance controls the radius shown on the Navigation
view for the outer compass circle. This radius also drives the size of the
target circle, which is a third of the compass radius.
 Stop Radius - This distance controls the radius at which the navigation view
changes to a stop state.
 About Tab - Displays various stats and details on the current install of SMS
Mobile, the mobile device and OS, and available memory.
Attributes/Properties Setup
10