HP MPX200 Multifunction Router - Manual (Page 97)

Outbound Port (1=GE1, 2=GE2, ...) [GE1 ] 3
Header Digest (0=Enable, 1=Disable) [Disabled ]
Data Digest (0=Enable, 1=Disable) [Disabled ]
iSCSI Login for selected target was successful
3. Optional: To stop this process before reaching the end of the list, press Q+Enter .
Zoning the Fibre Channel host and MPX200 router
To configure the MPX200 to the Fibre Channel SAN and the connection to the EqualLogic array,
for the Fibre Channel SAN, create a list of fabric zones that contain the WWPN associated with
the servers by entering their values in
Table 4 (page 97) .
Table 4 Zone host with router for Fibre Channel-based ports
Server, MPX200, storage
name
Zone members (WWPNs) Fibre Channel zone name
Fibre Channel switch and IP
address
Figure 3 (page 97) shows the Fibre Channel switch GUI where a zone is configured with the router
to see the targets.
Figure 3 Zone configured with router
Mapping the iSCSI target into the SAN and providing host access to the
storage LUN
IMPORTANT:
This procedure maps the iSCSI target into the Fibre Channel SAN, and provides LUN access from
the host to the storage. Make sure you select the correct MPX200 Fibre Channel port to present
to the target.
Zoning the Fibre Channel host and MPX200 router 97