HP MPX200 Multifunction Router - Manual (Page 84)

A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
GE Port (1=GE1, 2=GE2, ...) [GE1 ]
Is Local IP already configured (y=yes, n=no) [y ] n
Local IP Address (IPv4 or IPv6) [0.0.0.0 ] 1.1.1.94
Subnet Mask [0.0.0.0 ] 255.255.255.0
Gateway [0.0.0.0 ]
Remote IP Address (IPv4 or IPv6) [0.0.0.0 ] 1.1.1.93
VLAN (0=Enable, 1=Disable) [1=Disable]
Test Duration in Minutes (multiples of 5) [10 ]
Server port to connect to (3225 FCIP/3260 iSCSI) [ ] 3260
Checking whether resources are available to start WAN Link Test
........
WAN Link Test initialization completed successfully
The following example shows the wanlinktest show command on a server:
MPX200 <1> (admin) #> wanlinktest show
Wanlinktest server is listening on interface 1.1.1.93 socket port 3260
The following example shows the wanlinktest show command on a client:
MPX200 <1> (admin) #> wanlinktest show
Not completed single iteration yet
WAN Link Test started for the duration of 10 Minutes at on GE Port 1
LocalIP: 10.10.10.94 RemoteIP: 10.10.10.93
Active Iterations.... Press Control+C to quit command
StartTime EndTime RTT TCP B\W UDP B\W Jitter PktDrop%
--------- --------- --- ----- ----- ------ --------
16:36-Nov/09/2012 16:42-Nov/09/2012 <0.1ms 991Mb 759Mb <0.1ms 0.006%
16:42-Nov/09/2012 16:48-Nov/09/2012 <0.1ms 991Mb 992Mb <0.1ms 0.012%
Done With WAN Link Test
WAN Link Test started for the duration of 10 Minutes at 16:35-Nov/09/2012 on
GE Port 1
LocalIP: 10.10.10.94 RemoteIP: 10.10.10.93
Average So Far
StartTime EndTime RTT TCP B\W UDP B\W Jitter PktDrop%
--------- --------- --- ----- ----- ------ --------
16:35-Nov/09/2012 16:48-Nov/09/2012 <0.1ms 991Mb 875Mb <0.1ms 0.009%
You can ftp wan_link_test_results.stats file to get overall statistics
information
Done With WAN Link Test
The following example show the wanlinktest stop command during an active test:
MPX200 <1> (admin) #> wanlinktest stop
Stopping the test
Wan Link Test stopped successfully
The following example show the wanlinktest stop command following test completion:
MPX200 <1> (admin) #> wanlinktest stop
84 Command reference