HP MPX200 Multifunction Router - Manual (Page 82)

will loose access to disks.
Index State VpGroup Port (WWNN,WWPN/iSCSI Name)
----- ----- ------ ---- ----------------------
0 Online 1 FC1 20:00:00:0c:50:a6:67:39,21:00:00:0c:50:a6:67:39
Please select a target from the list above ('q' to quit): 0
All attribute values that have been changed will now be saved.
traceroute
Prints the route a network packet takes to reach the destination specified by the user.
Authority
Admin session
Syntax
traceroute
Example
MPX200 <1> (admin) #> traceroute
A list of attributes with formatting and current values will follow.
Enter a new value or simply press the ENTER key to accept the current value.
If you wish to terminate this process before reaching the end of the list
press 'q' or 'Q' and the ENTER key to do so.
IP Address (IPv4 or IPv6) [0.0.0.0] 172.35.14.17
Outbound Port (0=Mgmt, 1=GE1, 2=GE2, ...) [Mgmt ] 0
Tracing route to 172.35.14.17 over a maximum of 30 hops:
1 172.17.136.2 0.4ms 0.3ms 0.5ms
2 10.7.9.5 1.1ms 1.1ms 1.1ms
3 172.21.130.233 2.7ms 2.7ms 2.6ms
4 172.21.4.245 291.4ms 291.4ms 291.4ms
5 172.21.4.246 413.6ms 417.1ms 439.2ms
6 10.35.9.1 459.1ms 465.6ms 480.0ms
7 172.35.14.17 495.3ms 483.0ms 505.9ms
Traceroute completed in 7 hops.
WAN link test
Collects data for the WAN link.
Authority
Admin session
Syntax
wanlinktest {setup | start | show | stop}
Keywords
setup configures the WAN link test parameters on the server side of the WAN link.
start begins running the WAN link test.
show displays the outcome of the WAN link test.
stop terminates the WAN link test.
82 Command reference