HP MPX200 Multifunction Router - Manual (Page 129)

Table 9 MPX200 Router log messages (continued)
Description
Msg
type Module
type
Log message ID
Response queue entry contains an
invalid handle. Fatal FC #%d: QLProcessResponseQueue: Invalid
handle %x, type %x
102746
Fibre Channel processor external
SRAM parity error count exceeded
limit; Fibre Channel port disabled. Fatal FC #%d: QLTimer: Ext Ram parity error
exceed limit cnt 0x%x, limit 0x%x,
Disabled adapter
102752
Fibre Channel processor heartbeat
failed. Fatal FC #%d: QLTimer: Heartbeat failed 102755
Fibre Channel processor being
restarted. Fatal FC #%d: QLRestartRisc: restart RISC 102800
Fibre Channel processor received a
SCSI command for an unknown Error FC #%d: QLUtmReceiveIo: Path invalid/FW
No resource count %x
106583
target path or has run out of
resources to issue additional
commands.
Fibre Channel processor was
disabled by an IOCTL request to the
driver. Error FC #%d: QLIoctlEnable: Adapter disabled 106589
Fibre Channel processor firmware
failed initialization. The request to Error FC #%d: QLIoctlEnable: Initialize FW
error
106590
initialize was received by the driver
in an IOCTL request.
Fibre Channel processor failed the
external loopback test. Error FC #%d: QLIoctlRunDiag: Diagnostic
loopback command failed %x % %x %x
106592
Fibre Channel processor failed to
re-initialize in response to an IOCTL
disable request. Error FC #%d: QLIoctlDisable: Re-initialize
adapter failed
106593
Fibre Channel processor reported a
link down condition. Error FC #%d: QLIsrEventHandler: Link down (%x) 106803
Fibre Channel processor reported an
unexpected asynchronous event. The Error FC #%d: QLIsrEventHandler: Unexpected
async event (%x), MB1=%x, MB2=%x,
MB3=%x, MB4=%x, MB5=%x, MB6=%x, MB7=%x
106813
mailbox registers provide status,
event code, and data related to the
event.
Fibre Channel controller reported an
invalid Entry Status %x, type %x. Error FC #%d: QLProcessResponseQueue: Invalid
EntryStatus %x, type %x
106847
Fibre Channel controller failed to
provide a heartbeat. Error FC #%d: QLTimer: Heartbeat failed 106851
Driver has determined that the Fibre
Channel link is unreliable and Error FC #%d: QLTimer: Link error count (0x%x)
exceeded, link down
106853
unusable due to the number of errors
encountered. The link has been taken
down.
Fibre Channel processor was unable
to obtain the number of loop IDs Error FC #%d: QLReserveLoopId: out of loop Ids 106912
required. This failure occurs only
when the Fibre Channel processor is
running multi-ID firmware.
Driver was unable to re-establish
connection to the target within the Error FC #%d: QLMarkDeviceOffline: Device Id:
%x marked offline, cLinkDownTimeout =
%x, cPortDownRetryCount=%x
106928
timeout and retry counts, and is
therefore marking it offline.
129