HP MPX200 Multifunction Router - Manual (Page 137)

Table 9 MPX200 Router log messages (continued)
Description
Msg
type Module
type
Log message ID
The TCP link for FCIP route #n has
disconnected. The MAC or Ethernet Error FCIP FcipRoute#%d: TCP Link Down, MAC
Stats: Tx Dropped Count=%ld Rx Dropped
172303
statistics include total packet dropped Count=%ld Tx Pause Count=%ld Rx Pause
Count=%ld during transmit (TxDropped), total
packet dropped during receive
(RxDropped), total Ethernet pause
frames transmitted (TxPause), and
total Ethernet pause frames received
(RxPause).
The total number of TCP
retransmissions that occurred in the Error FCIP FcipRoute#%d: Tcp Retranmissions in
last 10 Sec %d, OutStanding
Completions %d FC Frames
172304
last ten seconds before the link was
brought down due to a keepalive
timeout. It also displays the total
number of outstanding transmissions
that were pending to be transmitted
through the GbE port.
The FCIP route #n went down
because the Fibre Channel port on
the remote peer went down. Error FCIP FcipRoute#%d: FC link on the remote
peer went down
172322
TCP link for FCIP route #n has been
established. Info FCIP FcipRoute#%d: TCP Link Up 184515
FCIP link is up for FCIP route #n. Info FCIP FcipRoute#%d: FCIP Link Up 184536
FCIP route #n: Incorrect VLAN
configuration. Error FCIP FcipRoute#%d: VLAN Info Unavailable 184542
Ethernet port was not able to
negotiate the configured speed. Error NIC QL3xxx:%s: Auto Negotiation error
detected
205571
Ethernet port speed is not supported. Error NIC QL3xxx:eth%d: Unsupported speed
portConfig 0x%x
205572
Ethernet device could not be
configured. Error NIC QL3xxx:ql3xxx_probe: cannot allocate
ethernet device %s
206080
The Ethernet port was not able to
register as a network device resulting Error NIC QL3xxx:ql3xxx_probe: cannot register
network device %s
206089
in a port initialization error for the
specified network device.
The total number of TCP checksum
errors detected on the Ethernet link
belonging to the eth#%d port. Error NIC QL3xxx:eth%d: TCP/IP checksum error -
TotalChecksumErrorCount = %lu
206114
Ethernet port is operating at 100
mbps speed. Info NIC QL3xxx:%s: PHY Downshift occurred 217856
Ethernet link is up. Info NIC QL3xxx:%s: Link Up 217857
Ethernet link is down. Info NIC QL3xxx:%s: Link Down 217858
Ethernet port is down. Info NIC QL3xxx:%s Adapter Down 218389
Ethernet port is up. Info NIC QL3xxx:%s Adapter Up 218401
Uncorrectable memory error detected
at address provided in log message. Fatal System "memory monitor: Detected
Uncorrectable Ecc %08lx system is
rebooting in 5 secs\n"
233473
Attempt to register the interrupt
handler failed. Fatal System "Failed to register interrupt
handler!\n"
233474
137