HP MPX200 Multifunction Router - Manual (Page 14)

date
Displays or sets the date and time. To set the date and time, you must enter the information in the
format MMDDhhmmCCYY (numeric representation of month-date-hour-minute-century-year). The new
date and time takes effect immediately.
Each blade has its own independent date set. Properly setting the date ensures that event log entries
are dated correctly. The date must be set before you apply any feature keys or licenses.
Authority
Admin session required to set the date and time. No authority is required to display the current
date and time.
Syntax
date [<MMDDhhmmCCYY>]
Keywords
MMDDhhmmCCYY If you omit MMDDhhmmCCYY, the command displays the current date, which
does not require an Admin session.
Notes
Always set the time using GMT and UTM.
You must disable the NTP to set the time with the date command. See “set ntp” (page 47) for
information about NTP.
Examples
MPX200 <1> (admin) #> date 010214282011
Fri Jan 2 14:28:00 2011
MPX200 <1> (admin) #> date
Fri Jan 2 14:28:14 2011
exit
Exits the command line interface and returns you to the login prompt. (Same as the quit command.)
Authority
None
Syntax
exit
Examples
The exit command behaves differently depending on whether you are at the chassis or blade
management level.
At the chassis management level, exit returns you to the login prompt. The following example
shows the exit command for the chassis:
MPX200 #> exit
MPX200 login:
At the blade management level, exit returns you to the chassis management level. The following
example shows the exit command for the blade:
14 Command reference