HP MPX200 Multifunction Router - Manual (Page 120)

Table 9 MPX200 Router log messages (continued)
Description
Msg
type Module
type
Log message ID
Unable to create an object for the
target device; exceeded the
maximum number of target devices. Error App QLBA_CreateTargetDeviceObject: Too
many devices
41058
Unable to create an object for the
target node; exceeded the maximum
number of target devices. Error App QLBA_CreateTargetNodeObject: Too many
devices
41060
Memory unavailable for LUN object. Error App QLBA_CreateLunObject: LunObject memory
unavailable
41067
Unable to create an object for
initiator object; exceeded the
maximum number of initiators. Error App QLBA_CreateInitiatorObject: Too many
initiators
41077
Process control block status indicates
that a PCI error occurred during a
target operation. Error App QLBA_DisplayTargetOperationStatus: PCI
Error, Status 0x%.2x
41096
Process control block status indicates
that a DMA error occurred during an
initiator operation. Error App QLBA_DisplayInitiatorOperationStatus:
DMA Error, Status 0x%.2x
41106
Process control block status indicates
that a transport error (protocol) Error App QLBA_DisplayInitiatorOperationStatus:
Transport Error, Status 0x%.2x
41107
occurred during an initiator
operation.
Process control block status indicates
that a data overrun error occurred
during an initiator operation. Error App QLBA_DisplayInitiatorOperationStatus:
Data Overrun, Status 0x%.2x
41111
iSCSI login failed between receipt of
PDU and request for the data
segment. Error App QLIS_LoginPduContinue: Operation
failed. Initiator 0x%x, TPB status
0x%x
41234
iSCSI login failed due to unsupported
version number in received login
PDU. Error App QLKV_ValidateLoginTransitCsgNsgVersion
failed (status 0x%x)
41238
iSCSI Login PDU contains invalid
initiator name. The format and Error App QLIS_LoginPduContinue: Invalid
initiator name. Initiator:
41257
character set used to form the initiator
name is invalid.
iSCSI target login was attempted to
a portal (iSCSI1 or iSCSI2) on which
the target is not presented. Error App QLIS_LoginPduContinue: Target not
configured for Portal
41265
iSCSI Login PDU received for a target
with a target name unknown to the
router. Error App QLIS_LoginPduContinue: Target not
found. Target name:
41267
iSCSI Login PDU received without a
target name for a normal session. Error App QLIS_LoginPduContinue: Missing target
name
41268
iSCSI Login PDU received without an
initiator name key/value. Error App QLIS_LoginPduContinue: TSIH is 0 but
InitiatorName key/value not provided
41270
iSCSI Login PDU received with an
incorrect initiator task tag for a Error App QLIS_LoginPduContinue:
CONN_STATE_IN_LOGIN, Unknown
InitTaskTag
41272
session that is partially logged in.
This occurs if a login PDU other than
the initial login PDU used an initiator
task tag that was different from the
120 Log messages