HP MPX200 Multifunction Router - Manual (Page 65)

associated with any configured FCIP routes.
Displaying bytes/sec (target mode write)... (Press any key ato
stop display)
GE1 GE2 GE3 GE4 FC1 FC2
---------------------------------------
0 0 0 0 0 0
show port statistics
Displays Fibre Channel or GbE port statistics.
Authority
None
Syntax
show portstats {{fc | gige} {hours | mins} }
Keywords
fc specifies the display of Fibre Channel port statistics.
gige specifies the display of GbE port statistics.
mins specifies that display of statistics by the minute.
hours specifies the display of statistics by the hour.
duration specifies the duration in minutes or hours.
Examples
MPX200 <1> #> show portstats fc 1 mins 10
This will display monitoring statistics of FC Port 1 for last 10 minute(s).
Statistics are displayed in reverse order.
If the router has been rebooted recently, the statistics are displayed
starting from the last reboot.
The statistics contain:
Current Date (once) at start, Time Stamp (TimeStamp),
TX bytes (TxByte), RX bytes (RxByte),
TX frames (TxFrame), RX frames (RxFrame),
FC Invalid CRC Count (CRCErr),
FC Link Failure Error Count (LinkErr),
FC Loss of Sync Error Count (LossSync),
FC Loss of Signal Error Count (LossSgnl),
FC Primitive Sequence Protocol Error Count (PSPErr)
FC Invalid Transmission Word Count (TXWrdErr)
Current Date 12/21/2011
MPX200 <1> #> show portstats fc 1 hours 2
This will display monitoring statistics of FC Port 1 for last 2 hour(s).
Statistics are displayed in reverse order.
If the router has been rebooted recently, the statistics are displayed
starting from the last reboot.
The statistics contain:
Current Date (once) at start, Time Stamp (TimeStamp),
TX bytes (TxByte), RX bytes (RxByte),
TX frames (TxFrame), RX frames (RxFrame),
FC Invalid CRC Count (CRCErr),
FC Link Failure Error Count (LinkErr),
FC Loss of Sync Error Count (LossSync),
show port statistics 65