HP MPX200 Multifunction Router - Manual (Page 134)

Table 9 MPX200 Router log messages (continued)
Description
Msg
type Module
type
Log message ID
Router configuration has changed. Info User qapisetbridgebasicinfo_1_svc:Bridge
configuration changed
151897
GE port %d was enabled user. Info User GE%d: Port status changed by user to
ENABLED.
151908
GE port %d was disabled by user. Info User GE%d: Port status changed by user to
DISABLED.
151909
Fibre Channel port %d was enabled
by user. Info User FC%d: Port status changed by user to
ENABLED.
151910
Fibre Channel port %d was disabled
by user. Info User FC%d: Port status changed by user to
DISABLED.
151911
Target at WWPN:
xx.xx.xx.xx.xx.xx.xx.xx has been
mapped to iSCSI portal %d. Info User qapimaptargetdevice_1_svc: Target
WWPN: %.2x%.2x%.2x%.2x%.2x%.2x%.2x%.2x
mapped to iSCSI portal %d.
151912
Target at WWPN:
xx.xx.xx.xx.xx.xx.xx.xx has been
unmapped from iSCSI portal %d Info User qapimaptargetdevice_1_svc: Target
WWPN: %.2x%.2x%.2x%.2x%.2x%.2x%.2x%.2x
unmapped from iSCSI portal %d.
151913
FCIP route #n has been successfully
added. Info App FcipRoute#%d Added 152069
FCIP route #n has been successfully
modified. Info App FcipRoute#%d Modified 152070
FCIP route #n has been successfully
removed. Info App FcipRoute#%d Removed 152071
An Initiator's configuration has
changed. Info User qapiaddmodifyinitiator_1_svc :
Initiator Configuration Changed
152082
An Initiator has been removed. Info User qapiremoveinitiator_1_svc : Initiator
Removed
152083
A set array was performed on one
of the arrays. Info User qapisetmigrfctargets_1_svc:
Configuration Changed for migration
target
152096
Encountered an error while updating
the migration log entry. Some Info User LogMigration: Error in Writting log
file
152099
migration log entries might be
missing.
Group with ID specified in the log
was added. Info User qapiaddgroup_1_svc: Added Group with
id %d
152100
Group with ID specified in the log
was removed. Info User qapiremovegroup_1_svc: Removed Group
with id %d
152101
Group with ID specified in the log
was updated. Info User qapiupdategroup_1_svc: Updated Group
with id %d
152102
Serial schedule jobs scheduled to
start at time specified in the log. Info User qapisetserialjobs_1_svc: Serial Time
%lu
152103
Readjust priority command completed
with an error. Error code 2 indicates Info User qapireadjustpriority_1_svc: Readjust
Priority Failed on line %d with error
%d
152104
no scheduled jobs were found. Error
code 16 indicates a job with priority
1 was configured.
134 Log messages