HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 34)

34 2 - C ONFIGURING THE HP EFS WAN A CCELERATOR
Figure 2-5. Setup: Optimization Service - In-Path Rules Page, Pass-Through Rules
3. Under Add New Rule, select Pass-Through from the Type drop-down list.
4. Select start, end, or a rule number from the Insert Rule At drop-down list to
insert a rule in the Rules list. When you specify a particular rule number, the rule
is placed after the rule number you specified and before the default auto-discovery
rule.
5. Type the IP address for the source subnet in the Source Subnet text box. Use the
following format: 0.0.0.0/0.
6. Type the IP address, port, or port label for the destination subnet, in the
Destination Subnet and Port text boxes. To specify all ports, type all in the Port
text box.
7. Optionally, under Advanced Options, select the VLAN identification number from
the VLAN Tag ID drop-down list box. All specifies the rule applies to all VLANs;
Untagged specifies the rule applies to non-tagged connections.
8. Click Add Rule to apply the rule to the running configuration.
9. Optionally, under Additional Options, click Enable Computation of Neural
Heuristics to enable the HP EFS WAN Accelerator to select the optimal packet
framing boundaries for SDR.