HP StorageWorks Enterprise File Services WAN Accelerator - Manual (Page 25)

HP S TORAGE W ORKS EFS WAN A CCELERATOR M ANAGEMENT C ONSOLE U SER G UIDE 25
2 -
C
ON
FIG
URING
TH
E
HP
EF
S
WA
N
A
C
C
EL
ER
ATO
R
‹ Optionally, click Enable Layer 4/PBR/WCCP Support on Interface
wan0_0 if you are using a Layer 4 switch, PBR, or WCCP to redirect traffic.
The interface names for the bypass cards are a combination of the slot number
and the port pairs (wan_).
NOTE: If you have multiple WAN ports, Layer 4, PBR, and WCCP is only supported on the
first in-path interface.
‹ Optionally, click Enable Optimizations on Interface inpath0_0 to enable in-
path support for additional bypass cards. The interface names for the bypass
cards are a combination of the slot number and the port pairs
(inpath_).
‹ Optionally, click Enable Optimizations on Interface inpath0_1 to enable in-
path support for additional bypass cards. The interface names for the bypass
cards are a combination of the slot number and the port pairs
(inpath_).
3. Click Apply to apply your settings to the running configuration. (Apply your
settings to test a new configuration before committing it to memory.)
4. Click Save to write your settings to memory or click Reset to return the settings to
their previous values.
To enable out-of path
support 1. Click the Setup tab to display the Setup: Optimization Service - General Settings
page.
Figure 2-2. Setup: Optimization Service - General Settings Page