HP 8.20q Fibre Channel Switch - Manual (Page 81)

HP SN6000 Fibre Channel Switch QuickTools Switch Management User Guide 81
To install firmware:
1. Choose one of the following:
• To install firmware on a switch, open the switch faceplate display, and select Switch > Load
Firmware.
• To install firmware on a statck, open the stack faceplate display, and select Stack > Load Firmware.
NOTE: The Load Firmware dialog for a stack shows all switches in the stack, and allows you to
load firmware on all switches in the stack. When loading firmware on all switches in the stack, each
phase of the load firmware process is performed on all switches in the stack before the next phase
of the process is started.
2. In the Load Firmware dialog box, choose one of the following:
• Select a firmware image file from the Version drop-down list.
• To change the folder (path), click Browse to search for a different firmware image file, select the
desired folder, and then click Rescan to search the selected folder.
3. Click Start to begin the firmware load process.
You will be shown a message indicating the type of reset required in order to activate the firmware.
4. Click OK to continue the firmware installation.
5. Click Close to close the Load Firmware dialog box.
Using Call Home
The Call Home feature enables you to configure switches to send alerts and events to pagers and email.
You can configure the types of events to cover and where to send the alerts. Use the Call Home Setup
dialog box ( Figure 43 ) to configure call home parameters. To display the Call Home Setup dialog box,
open the Switch menu, select Call Home > Setup.
IMPORTANT: The Call Home feature provides an email notification capability for the switch. This service
has no relationship with the HP Call Home feature, which notifies HP services.
Figure 43 Call Home Setup dialog box