HP 3PAR System Reporter Software - Manual (Page 37)

System Reporter 2.8 3PAR System Reporter User’s Guide
3.1
Installation, Configuration, Update, and Removal
3
Installation, Configuration,
Update, and Removal
This chapter describes how to install and configure as well as remove the 3PAR System
Reporter components.
3.1 Before You Begin
Before installing 3PAR System Reporter components, select a system on which to run the
System Reporter sampler and Web server. This system must use Windows® Server 2003,
Windows® Server 2008 or Red Hat® Enterprise Linux 5.
If necessary, perform the following setup activities on the designated Windows® or Red Hat®
Linux server:
 (Optional). To avoid a DHCP-assigned address changing, assign a fixed IP address to the
system.
 Install the InForm OS Command Line Interface (CLI), version 2.3.1 or beyond.
NOTE: The CLI installer executable for the InForm OS can be found on the System
Reporter CD at: Windows\CLI\setup.exe (for Windows) or Linux/CLI/
setup.bin (for Linux)
See the InForm OS Administrator’s Guide, located on the System Reporter CD at:
Document/CLI\231_CLI_Administrator_Manual.pdf , for instructions on
installing the InForm CLI.