HP 3PAR System Reporter Software - Manual (Page 110)

5.18 Creating Custom Reports
3PAR System Reporter User’s Guide System Reporter 2.8
5.3.4.1 Standard Report Types
The following standard report types are available ( Table 5-6 ):
Table 5-6. Standard Report Types
Report Type Purpose
Versus Time Display metrics versus time. The beginning of the time range is
specified by the Begin/At Time control (see Begin/At Time on
page 5.31) and the end of the time range is specified by the End
Time control (see on page 5.31).
Unless the Compare control is available and set to something
other than none, the Versus Time report shows aggregate
metrics for all the selected objects over a range of time. See
Figure 5-6. Versus Time Report Example on page 5.20 for an
example.
If the Compare control (see section 5.3.4.3 Compare on
page 5.25) is set to a specific object, then the Versus Time
report plots the metrics separately for each of up to 16 of the
objects so that they can be compared. Figure 5-7. Versus Time
with Compare=System Report Example on page 5.21 shows an
example where the performance of systems is being compared.
At Time Display metrics at the time specified by the Begin/At Time
control (see Begin/At Time on page 5.31). For this type of report,
the Group By (see section 5.3.4.5 Group By on page 5.25) and
Order By (see section 5.3.4.6 Order By on page 5.28) controls are
enabled and can be used to compare different groupings of
object type. Figure 5-8. Group By System:Host At Time Report
Example on page 5.22 shows an example of an example with
System and Host selected in the Group By control and IOPs/s
selected in the Order By control.