HP 3PAR System Reporter Software - Manual (Page 111)

5.19 Creating Custom Reports
System Reporter 2.8 3PAR System Reporter User’s Guide
For each report type, controls in the report menu that do not apply to that report type are
disabled.
Histogram
Versus Time
Display service time histogram versus time, with a separate data
series for each service time bucket between the Low Bucket (see
5.3.4.7 Low Bucket on page 5.30) and the High Bucket (see
5.3.4.8 High Bucket on page 5.30).
The beginning of the time range is specified by the Begin/At
Time control (see Begin/At Time on page 5.31) and the end of
the time range is specified by the End Time control (see on
page 5.31). See Figure 5-9. Histogram Versus Time Report
Example on page 5.23.
Histogram At
Time
Display histogram of metrics at the time specified by the Begin/
At Time control (see Begin/At Time on page 5.31). This control is
only available for PD, LD, Port and VLUN performance reports.
See Figure 5-10. Histogram At Time Report Example on
page 5.24.
Table 5-6. Standard Report Types
Report Type Purpose
NOTE: See 9.4 Adaptive Optimization Reports for complete details on Adaptive
Optimization reports.