HP 3PAR System Reporter Software - Manual (Page 175)

7.7 Adding, Removing and Re-Configuring InServ Storage Systems
System Reporter 2.8 3PAR System Reporter User’s Guide
■ To re-configure sampling parameters for a storage server see section 7.3.4 Re-Configuring a
Storage Server Sampling on page 7.8
7.3.1 Adding a Storage Server
Refer to section 3.9.1 Adding InServ Systems on page 3.31 for instructions on how to add an
InServ system to be sampled by System Reporter.
7.3.2 Verifying Addition of a Storage Server
To verify that a new storage server was successfully added to the system table refer to 3.9.1.2
Verifying Installation on page 3.32.
7.3.3 Removing a Storage Server
You can remove a storage server from the list of systems being sampled by System Reporter as
follows.
1 Point your browser at the Web server where Apache HTTP Server and the 3PAR System
Reporter Web server scripts are installed.
The 3PAR System Reporter main window appears.
2 Click on Policy Settings in the Extras Menu area.
The System Reporter Policies window appears.
3 Choose the InServ Systems tab.
4 Click Remove InServ.
5 Choose the storage server from the drop-down list and then click Submit Query.
6 An alert window appears confirming that the InServ server was removed.
NOTE: For performance type reports, you may only be able to see high resolution
performance information at first. For space type reports, it may take more than
ten minutes before you can sample high resolution data. Daily and hourly data
samples may take even longer.