Figure 37 add paths window, 37 add paths window – HP StorageWorks XP Remote Web Console Software User Manual
Page 62
62
External Storage XP for the XP10000/XP12000
NOTE:
Use the Add Paths window to add paths to multiple external LUs at one time. However, path
settings might not be applied because of the current path setting of each volume. After you click Set in the
Add Paths window, check whether or not the new path settings can be applied in the Path Setting window
for each external LU. If the setting cannot be applied, the setting from the Add Paths window does not
appear on the Path Setting window. The setting from the Add Paths window also does not appear in the
Preset list or in the LU Operation pane.
Figure 37
Add Paths window
The Add Paths window provides the following information:
•
Port
Select the appropriate port from the drop-down list. After you select a port, you can add paths.
•
Selected Paths
WWNs that appear in this field are paths that will be added as ports that configure alternate paths.
WWNs indicate the ports on the external disk array. This field is empty until you add paths from
Unselected Paths.
•
Unselected Paths
External disk array ports (WWNs) that can configure the path connecting with the port selected in Port.
Select WWNs from this list to add as alternate paths.
•
Set
Moves selected WWNs to Selected Paths.
•
Release
Moves selected WWNs to Unselected Paths.
•
OK
Saves settings in the Add Paths window, closes the Add Paths window, and displays the Path Setting
window.
•
Cancel
Cancels all settings in the Add Paths window, and closes the window.
To add alternate paths to multiple external LUs:
1.
In the External Storage XP operations pane, click LU Operation. The LU Operation pane appears.
2.
In the Device Tree, select an external LU group number. Information about external LUs mapped as
internal LUs appears in the Device List.
3.
Select multiple external LUs in the Device List, right-click, and select Add Paths. The Add Paths window
appears.
4.
Select the appropriate port from Port. External disk array ports (WWNs) that can configure the path
connecting with the selected port appear in Unselected Paths.
5.
Select WWNs from Unselected Paths, and click Set to move them to Selected Paths.
6.
When you are finished selecting paths, click OK to save the settings. The Path Setting window appears.