Installing the data exchange software, Installing data exchange on unix-based platforms, Bit data exchange software – HP XP P9500 Storage User Manual
Page 60
Linux
NCR
SVR4
Solaris
True64
Win-
dows
Sequent
Dynix
HP-UX
IBM
AIX
YES
NO
NO
YES
YES
YES
YES
YES
NCR
SVR4
CHK = sharing allowed only if volume has no label.
Installing the Data Exchange Software
The Data Exchange software must be installed on the open-system servers attached to the storage
system. Data Exchange software installation for UNIX-based platforms is different from Data Exchange
installation on Windows hosts. The following sections provide instructions for installing Data Exchange
version 01-02-4x and later. For instructions on installing earlier versions, see previous versions of this
document.
Installing Data Exchange on UNIX-Based Platforms
32-Bit Data Exchange Software
To install the 32-bit Data Exchange software on a UNIX-based platform:
1.
If Data Exchange version 01-01-36 or later is installed (by the cpio command), you do not need
to uninstall it. A new installation will overwrite the previous version.
If Data Exchange version 01-01-24 or earlier is already installed (by the setup program), you
must uninstall this older version as follows before installing version 01-02-4x or later:
a.
Log in with the same user ID that was used to install the old Data Exchange software.
b.
If Data Exchange was installed from FD using the setup program, see “
Exchange Software on UNIX-Based Platforms
” on page 63 to remove Data Exchange.
c.
If Data Exchange was installed from DAT, or if you cannot find your Data Exchange
installation FD, move to the directory fcu/fal.o/dataset.h and remove Data Exchange
by entering:
# rm fcu fal.o dataset.h $HOME/FcuMf
If you cannot find the directory, you can use the following procedure:
# find / -name “fcu” −print
# find / -name “fal.o” −print
# find / -name “dataset.h” −print
# find / -name “FcuMf” -print
2.
Log in to the system as root.
3.
Insert the Data Exchange installation media (for example, CD-ROM) into the drive.
NOTE:
Verify that the device file for the CD-ROM drive exists. For Solaris, do not use volcheck
if the CD-ROM device file is not available for auto-mount.
Preparing for Data Exchange Operations
60