HP XP P9500 Storage - Manual (Page 164)

fcudata.prm.log ). Table 67 on page 164 lists and describes the FCU error codes for Windows
2000/Windows NT systems and provides instructions for resolving each error condition.
NOTE:
Error codes with a plus value are system errors. Windows systems system error codes are defined in
the errno.h file attached with Microsoft Visual C++.
Table 67 FCU Error Codes for Windows Systems
Recommended Actions Error Message and Description Error
Code
Make sure that the parameter definition file was
created correctly. If the parameter definition file
was created correctly, check the system error.
Parameter definition file: Open error
An error occurred when opening the
parameter definition file. -100
Make sure that the parameter count is correct.
Parameter: Count error
An error is detected in the parameter
count. -101
Make sure that the direction is specified cor-
rectly as mto or otm.
Parameter: Direction error
The data transfer direction is not correct.
-102
Make sure that the mainframe file name is set
correctly.
Parameter: Mainframe file name error
The mainframe file name is not correct.
-103
Make sure that the open system file name is set
correctly.
Parameter: Open system file name error
The open system file name is not correct.
-104
Make sure that the code conversion option is
specified as EA, EcA, No, or File_name (of your
code conversion table). This error may also be
reported if you mix 3390/3380 and OPEN-x
devices in the same Data Exchange volume
definition file.
Parameter: Code conversion error
The code conversion setting is not
correct. -105
Make sure that the padding option is specified
as Yes or No.
Parameter: Padding error
The padding setting is not correct.
-106
Make sure that the delimiter option is specified
as CRLF or No.
Parameter: Delimiter error
The delimiter setting is not correct.
-107
If you are adding delimiters for Windows sys-
tems, make sure that the delimiter option is
specified as CRLF (not just CR or LF). Parameter: Add parameter error
The delimiter setting is not correct.
-108
Specify only one empty setting.
Parameter: Empty duplication error
More than one empty setting is
specified. -109
Troubleshooting 164