HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 87)

Command line 87
Item Description
Syntax
add snmp-access Network=
Parameter
Network (required) The network IP address in the format IP Address/Netmask Bits. The IP
address must be unique and the starting address of an IP subnet range.
Example
->add snmp-access Network=192.168.0.0/24
Adds a new range(s) of IP addresses
Item Description
remove snmp-access Remove already configured range(s) of IP addresses that were permitted to
access VC Ethernet modules through the SNMP interface.
Syntax
remove snmp-access Network= | *
Parameter
Network (required) The network IP address of a configured SNMP access
Examples
->remove snmp-access Network=192.168.0.0
Removes a range(s) of IP addresses
->remove snmp-access *
Removes all configured ranges of IP addresses
Item Description
show snmp-access Display the ranges of IP addresses that are already configured to access VC
Ethernet modules using the SNMP interface.
Syntax
show snmp-access
Example
->show snmp-access
Displays all configured ranges of IP addresses
snmp-trap
Manage SNMP trap information.
Supported actions: add, help, remove, set, show, test
Item Description
add snmp-trap Adds a new SNMP trap destination.
You can configure up to five VC-Enet and five VC-FC SNMP trap destinations.
Avoid using duplicate trap destinations. Setting duplicate trap destinations can
result in duplicate traps being sent to the same destination, or only one of the trap
destinations being configured.
Syntax
add snmp-trap Address=
[Community=
string>][Format=][Severity=
severity|All|None>][DomainCategories=
category|All|None>][EnetCategories=
category|All|None>][FcCategories=
category|All|None>]
Parameter
Name (required) A unique name for the new trap being added