HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 160)

Configuring the Virtual Connect domain using the CLI 160
The login should succeed after the Virtual Connect Manager restarts on the backup Virtual Connect Ethernet
module. Allow up to 5 minutes, depending on the enclosure configuration.
If the command line option -failover is not included in the reset vcm command or a backup Virtual
Connect Ethernet module is not available, the command line displays the following message:
SUCCESS: The Virtual Connect Manager is being reset. Please wait...
You are logged out of the session after approximately 1 minute. If you attempt to log in to the module again,
you might receive the following error message:
Unable to communicate with the Virtual Connect Manager. Please retry again
later.
The login should succeed after the Virtual Connect Manager restarts. Allow up to 5 minutes, depending on
the enclosure configuration.