HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 7)

Introduction 7
• Modified the set statistics-throughput command to enable configuration of sample rate
settings
• Modified the show statistics-throughput command to display the current throughput statistics
settings, including statistics for subports
• Modified the default value of the Password property for the add user and set user commands to
8 characters
• Modified the default value of the MinPasswordLength property for the set user-security
command to 8 characters
• New managed elements:
o activity (on page 20 )
o connection-map (on page 23 )
o local-users (on page 55 )
o name-server (on page 61 )
o snmp-access (on page 86 )
Changes from VC 3.60 to VC 3.70/3.75
Command Changes Virtual Connect 3.60 Virtual Connect
3.70/3.75
show all
show enet-connection
show fc-connection
show fcoe-connection
show iscsi-connection
show profile
show server-port
(when the server-port
corresponds to a Flex-10
adapter)
The VC CLI displays real
WWN and MAC
addresses in these
commands when the server
profile is assigned.
VC users do not have a
way to see the current
MAC/WWN address
of the server ports
when the MAC
addresses are
configured as
“Factory-Default”.
The real WWN and
MAC addresses are
displayed.
add enet-connection
set enet-connection
add iscsi-connection
set iscsi-connection
Modified these commands
to allow for a "Disabled"
speed type. If the speed
type is "Disabled",
bandwidth is not allocated
and the server port status is
"Administratively
Disabled".
Disabled speed type is
not supported.
Disabled speed type is
supported.
help activity
show activity
The new object "activity" is
supported in VC 3.70,
enabling you to display
activity events being
performed by VC and the
step-wise progress of those
events.
Not supported All of these commands
are supported.
show config This command has been
modified to use bulk
commands to enhance
performance.
Bulk commands are
not supported.
Bulk commands are
supported.