HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 6)

Introduction 6
Introduction
What's new
The command line interface user guide contains the following changes for VC 3.70/3.75:
• The VC CLI displays the real WWN and MAC addresses in the following commands when the server
profile is assigned:
o show all
o show enet-connection
o show fc-connection
o show fcoe-connection
o show iscsi-connection
o show profile
o show server-port
This depends on whether the server-port corresponds to a Flex-10 adapter. The VC CLI only displays
physical WWN and MAC addresses for physical ports and leaves the fields blank for virtual/Flex
ports.
• Modified the following commands to allow for a "Disabled" speed type:
o add enet-connection
o set enet-connection
o add iscsi-connection
o set iscsi-connection
If the speed type is "Disabled", bandwidth is not allocated and the server port status is "Administratively
Disabled".
• Modified the show config command to use bulk commands to enhance performance
• Added the Type property to the add fabric command to allow the specification of a FabricAttach
or DirectAttach fabric for FlexFabric modules
• Added the NoFlood property to the set igmp command to allow or prevent the flooding of
unregistered multi-cast packets
• Modified the show ssl-certificate * output to display the new data fields when they are set in
the installed certificate
• Modified the save ssl-csr command to include additional certificate data fields
Additionally, if the existing key is 1024 bits, a 2048 bit key and certificate will be generated before the
certificate signing request (CSR) is created.
• Modified the reset statistics command to reset per-port statistics for the specified port ID and its
associated subports
• Modified the show statistics command to display common statistics for the subport