Aiphone JKW-IP - Manual (Page 45)

44 45
PC Application Basic Operations
5-1-7 Sensor Detection from Connected Equipment
You will be notif ied by the PC Application if sensors
connected to the master monitor station and IP Video
Intercom Adaptor are activated.
If a sensor detects an abnormality, or the connected call
button etc. is pressed, the Sensor Detection Tone occurs.
Sensor: 1 2 3 4 M (Blue)
MESSAGE EXTERNAL INPUT
or
EXTERNAL INPUT
Click [OFF].
The Sensor Detection Tone stops and the sensor indicator
turns off.
The Sensor Detection Tone can also be stopped in the
following situations.
Sensor Detection Tone Recovery
External (Sensor) input Description
IP Video Intercom
Adaptor external input
If the input latch setting is "30 sec.",
then it automatically stops after 30
seconds.
Master monitor station
external input
Stopped by the master monitor station.
If the input latch setting is "30 sec.",
then it automatically stops after 30
seconds.
*1
*1 However if the notification tone sounding time is set to
"Continuous" in the sensor input settings of the master
monitor station, the sensor indicator remains on until
recovery.
MEMO
For the sensor input settings, refer to "Sensor Input Settings"
on P.24 .
•
If the check mark is removed from Sensor Detection Tone
in "Event Notification Settings"
P.36 , the Sensor Detection
Tone will not occur.
If sensors are activated during communication, the Sensor
Detection Tone will not occur.
1.
2.
5-1-8 Option Output from IP Video Intercom Adaptor
You can operate equipment connected to the IP Video Intercom
Adaptor from the PC Application.
Click [OPTION].
MEMO
The [OPTION] button turns green while being operated.
To perform option output operations, you need to set the
Encryption Key.
•
•
Depending on the communication delay, the timing of
the button turning green and the actual control timing
may differ.
5-1-9 Balloon Notification
When an event occurs, a balloon notification is displayed on
the PC screen.
Balloon Notification Content
Notification Event Content
CALL FROM DOOR Indicates a call from a door station.
CALL FROM ROOM ST
Indicates a call from a master monitor
station.
EXTERNAL INPUT Indicates external input detection.
CANNOT RECORD.
SPACE IS FULL. Displayed when there is not enough
free space on the hard disk drive.
MEMO
If there is not enough free space on the hard disk drive during
a door call, the message "CANNOT RECORD. SPACE IS
FULL." is displayed.
The balloon notification disappears automatically when
the computer is operated. The balloon notif ication also
disappears if you click it while it is displayed.
See "Event Notification Settings" for Balloon Notification
settings. P.36
"CANNOT RECORD. SPACE IS FULL." is displayed even
when balloon notification is set to off.
•
•
•
•
1.
*
CALL