Aiphone AN-8050DS User Manual

Aiphone, Door station an^8050ds

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

aiphone

INSTALLATION MANUAL

DOOR STATION AN^8050DS

1. GENERAL DESCRIPTION

Designed to connect to the AN-8000EX IP Intercom

Exchange, the AN-8050DS is a door station featuring high

quality hands-free conversation and has a contact output

(momentarily closed) to remotely control an electronic door
lock.
Using with an electrical box or surface mounting box, the

station can be mounted to a wall.
The AN-8050DS is in full conformity with IP44 water-proof
and dust-proof standards. The operating temperature range
is -10 to +50°C.
As provided with guard nets inside to cover over the
openings of microphone and speaker, the AN-8050DS can
be installed free from care in public space.

2. WALL MOUNTING

2.1. Mounting to a 3-gang Switch Box (with cover)

M4 X 25 (accessory)

Notes

• The wall should be over 12 mm thick, and the opening In

the wall for an electrical box should be under 115 mm

(wide) by 162 mm (high).

• When using for electronic door lock control, fix the AN-

8050DS with tamper-proof screws such as "Torx" screws

to prevent it from being easily removed.

The AN-8050DS comes with 2 types of screws; oval head

combination screw M4 x 25 and oval head slotted screw

UNC N0.6x18.
For the electrical box provided with unified threads, use the

oval head slotted screws UNC No.6 x 18.

2.2. Mounting to the YS-13A Wall Mount Box

Install the YS-13A on a wall and mount the station in the

same way as 2.1.

3. INSTALLATION PRECAUTIONS

When installing the AN-8050DS

„

outdoors or at locations where it gets

edges,

wet with water, tightly seal the panel

edges. Besides, provide a weep hole

at the underside of the mounting box
to permit water to drain off.

AN-8050DS's
front panel

4. WIRING

4.1.

Connection to the Exchange

Connect the Exchange to the station's LINE terminals via
the E-7000TB Terminal Board as Illustrated.

AN-8000EX Exchange

16 lines

4.2. Connection to an External Relay

AN-8000EX Exchange

Diode

--------- -----------

Relay

External

power supply

+24 V DC

GND

LINE H C

Open collector output: 30 V DC, 50 mA

AN-8050DS (Rear panel)