Canon imageCLASS MF5960dn - Manual (Page 58)

3-4
Cop
ying
Copy Settings
Combination of Copy Settings
You can combine and use various copy settings.
This applies to Mode Memory registration and default settings ( →P. 3-13) as well.
However, the following limitation is found in the setting combination.
Nothing special.
When is set to , is changed to .
If is set other than when is set to , the setting in
will be cancelled.
<2-Sided>
• Depending on its paper size (selected paper drawer), 2-sided copy is not available.
• Depending on its paper size or paper type in the selected paper source, 2-sided copy is not available.
“e-Manual → Specifications → Paper → Supported Paper Types”
• This feature cannot be combined with .
• When you want to copy documents in a reduction ratio different from its default setting for <4 on 1>/<2 on 1>, secify
the later.
• is fixed at 100 % for .
• The frame width specified at increases/decreases according to the setting.
Depending on its paper size (selected paper source), 2-sided copy is not available.
<4 on 1>/
<2 on 1>
• If you want to copy a document in a copy ratio different from its default reduction ratio, specify the later.
• This feature cannot be combined with .
• is fixed at 100%.
• This feature cannot be combined with either 2-Sided Copy or .
Nothing special.
• This feature cannot be combined with N on 1 (<4 on 1> / <2 on 1>, ).
• The specified erase frame width increases/decreases according to the setting.
Nothing special.
Selecting Copy Papers
Copy mode screen Setting screen*
Copy: Press Start
100% LTR
2-Sided: Off
Copy Ratio: 100% Di
...
Paper: LTR:Plain
1
1
1
Select Paper
LTR:Plain
LTR:Plain
Paper Settings
1
Select the paper drawer using [ ] or [ ] → [OK]
* You can display the setting
screen also by selecting
in the copy mode
screen.
Select Paper/
Setting