Off-hook alarm, Change defaults, Register unit name (fax) – Canon imageCLASS MF5960dn User Manual
Page 111: Ecm tx, Pause time, Auto redial, P. 6-23)
6-23
U
sing
the
Fax
Func
tions
Off-Hook Alarm
Specify whether to sound an alarm when the telephone
handset is left unhooked and adjust the volume.
How to access the option
[
] (Menu)
→
Settings
(Bold: Default setting)
Off
No alarm sounds.
On
Off-Hook Alarm Volume:
1 to 3
The alarm sounds at the
specified volume.
Change Defaults
Change the default settings, which become effective
when the machine is turned ON and OFF or [
] (Reset) is
pressed.
How to access the option
[
] (Menu)
→ Settings> → Settings See the following section for more information. “Changing the Default Fax Settings” ( Register Unit Name (Fax) Register your name or company’s name (sender’s name). Once the information has been registered, it is printed at the top of each page that you are sending. [ ] (Menu) → Settings> → How to register the sender’s name Enter up to 24 alphanumeric characters. NOTE Where the sender’s name appears on the page The information is printed at the top of each page that you are Sending Date/Time Fax/Telephone Number (FAX No.) Page Number Sender Name (Unit Name) Telephone Number Mark 01/01/2011 02:07 PM FAX 123XXXXXXX CANON P.0001 ECM TX The ECM (Error Correction Mode) detects and corrects errors that occur during fax transmissions. It helps in minimizing sending errors caused by a poor connection. NOTE Check if the ECM is enabled on the receiving fax machine The ECM is effective only when it is enabled on both machines. An error occurs when the ECM is enabled The error may be caused by poor telephone line conditions. When telephone line conditions are poor It may take additional time to send your fax if a problem occurs How to access the option [ ] (Menu) → Settings> → Settings (Bold: Default setting) Off Disable the ECM. On Enable the ECM. Pause Time Press [ ] (Pause) to specify the pause length. For the instructions on how to enter a pause, see “Sending a How to access the option [ ] (Menu) → Settings> → Setting (Bold: Default setting) 1 to 2 to 15 (seconds) Auto Redial Enable auto redial for automatically redialing the fax number when the line is busy or a sending error occurs. Specify the number of redial attempts and the interval between these attempts. [ ] (Menu) → Settings> → Settings (Bold: Default setting) Off Disable Auto Redial →P. 6-7) to redial the number manually. On Redial Times: 1 to 2 to 10 (times) Set the number of redial attempts. Redial Interval: 2 to 99 (minutes) Set the interval (in minutes) between redial attempts. Redial When Err Occurs: Off, On Specify whether to redial the number when a sending error occurs.
How to access the option
sending.
when sending over the telephone line.
How to access the option