Options, Ecm rx, Incoming ring – Canon imageCLASS MF5960dn User Manual
Page 113: Remote rx, Auto rx switch, Sided printing, P. 6-25)
6-25
U
sing
the
Fax
Func
tions
Options
Configure the following options to receive a fax.
Fax Settings
RX
Function
Settings
RX Print
Settings
“Continue Printing When Toner Is Low” (
ECM RX
The ECM (Error Correction Mode) detects and corrects
errors that occur during fax transmissions. It helps in
minimizing sending errors caused by a poor connection.
NOTE
Check if the ECM is enabled on the receiving fax
machine
The ECM is effective only when it is enabled on both machines.
An error occurs even when the ECM is enabled
The error may be caused by poor telephone line conditions.
When telephone line conditions are poor
It may take additional time to receive your fax if a problem occurs
when sending over the telephone line.
How to access the option
[
] (Menu)
→ Settings> → Settings (Bold: Default setting) Off Disable the ECM. On Enable the ECM. Incoming Ring Specify whether or not the external telephone or the handset rings on an incoming call when to You can set the incoming call ring time. The machine automatically starts receiving a fax after the external telephone keeps ringing for a specified length of time. The machine’s speaker rings on an incoming fax only when [ ] (Menu) → Settings> → Settings (Bold: Default setting) Off The telephone does not ring on an incoming call. On Ring Times: 1 to 2 to 99 (times) The telephone rings on an incoming call. You can set the incoming call ring time in rings in Remote RX Specify whether to receive faxes remotely by dialing the ID number using the push-buttons of the external telephone connected to the machine when an incoming call comes. If you use the pulse line, press “*” (tone) and then dial the Remote RX ID. [ ] (Menu) → Settings> → Settings (Bold: Default setting) Off Disable remote retrieval. On Remote RX ID: 00 to 25 to 99 Enable remote retrieval. You can specify the ID number in RX ID>. Auto RX Switch Set the incoming call ring time before the machine switches to the fax mode automatically. This option can be enabled when the [ ] (Menu) → Settings> → Settings (Bold: Default setting) Off The machine does not switch to the fax mode automatically. On Incoming Ring Time: 1 to 15 to 99 (seconds) The machine switches to the fax mode automatically after the specified length of time. 2-Sided Printing Enable this option to print on both sides of paper. This saves excessive paper consumption. IMPORTANT Notes on 2-Sided printing Accurately attach the paper size switch lever. If the paper size “1-sided Printing and 2-sided Printing” ( How to access the option [ ] (Menu) → → <2-Sided Printing> Settings (Bold: Default setting) Off Print on only one side of paper. On Print on both sides of paper.
How to access the option
How to access the option
How to access the option
switch lever is not securely attached, documents may not
be fed properly or jammed.