Canon imageCLASS MF5960dn - Manual (Page 45)

2-9
D
ocumen
t and
P
aper
Handling
This section describes how to load paper in the paper drawer
and the multi-purpose tray.
NOTE
To set your choice of paper size or type
By default, the paper size is set to , and the type to (16 lb Bond-23 lb Bond)>. To use a different paper size or type, you
need to change the default settings.
“For the Paper Drawer” ( →P. 2-14)
In the Paper Drawer
Before loading paper in the paper drawer, see “Precautions
when Loading Paper” ( →P. 2-12).
NOTE
How to load the paper in the optional paper drawer (Drawer 2):
Same as in Drawer 1.
1
Pull out the paper drawer.
2
Slide the paper guides to the size mark for the
paper to be loaded.
While holding the lock release lever (A), adjust the length of the
paper guide.
(A)
(A)
* If you want to change the size of the paper to be loaded, be sure
to register the paper size in “Setting the Paper Size and Type”
( →P. 2-14).
3
Fan the document stack and even the ends.
Thoroughly fan in
small batches
Align the edges on a
flat surface a few times
4
Load the paper with the printing side down
so that it aligns with the rear side of the paper
drawer.
Load the paper in portrait orientation.
NOTE
When loading paper with a letterhead or logo
See, “Paper Loading Orientation” ( →P. 2-13), and load the paper in the
proper orientation.s.
5
Hold down the paper, then set it under the hooks
(A) on the paper guides.
(A)
(A)
(A)
Loading Paper