Operating procedures – Dwyer Series PUF User Manual
Page 15
3: Operating Procedures
11
3: Operating Procedures
QUICK START
VIEW EDIT SITE DATA
Enter data
Attach sensors
FLOW READING
Choose site / check/edit data
Attach sensors
FLOW READING
Set up a named site
At a one-off location
At a frequent location
Manage site details
Carry out any necessary calibration
How to adjust the Zero Flow Offset – Paragraph 3.5.2
How to adjust the Calibration Factor – Paragraph 3.5.3
How to adjust the Roughness Factor – Paragraph 3.5.4
How to adjust the Damping Factor – Paragraph 3.5.5
Set-up a monitoring or logging application
How to measure totalized flows – Paragraph 3.6.1
How to set up basic (manual) logging – Paragraph 3.6.3
How to set up auto-timed logging – Paragraph 3.6.4
How to set up logging ‘live’ to a PC – Paragraph 3.6.5
How to download saved data to a PC – Paragraph 3.6.6
How to print data – Paragraph 3.9
Configure the interfaces/ outputs
(Paragraph 3.7) (Paragraph 3.8)
Battery charging, Set date/time, Language, Backlight
Initial instrument setup
Connect and take basic flow readings
Rename a site
RS232 set-up – Paragraph 3.7.1
USB set-up – Paragraph 3.7.2
4-20mA ON/OFF – Page 35
4-20mA Calibration – Page 35
Pulse ON/OFF – Page 37
Pulse calibration – Page 38
Pulse frequency mode – Page 38
Pulse frequency calibration – Page 39