KEPCO EL Series Electronic Load Operator Manual P/N 243-1295 Firmware Version 4.00 to 4.xx - Manual (Page 85)

SERIES EL 071414
B-17
B.94 SYSTem:DAMPing? QUERY
SYST:DAMP?
Syntax: Short Form: SYST:DAMP? Long Form: SYSTem:DAMPing?
Returns x where x = integer from 0 (minimum damping) to 7 (maximum damping) (5 is maximum
damping for units with firmware version suffix B2 or lower)
Description: Inserts capacitance required to damp oscillation. Factory default setting is 7 (default is 5 for units
with firmware version suffix B2 or lower). See PAR. 3.14
B.95 SYSTem:ERRor? QUERY
SYST:ERR?
Syntax: Short Form: SYST:ERR? Long Form: SYSTem:ERRor?
Description: Returns next entry from the error message queue. Responds with the most recent error message
in a queue of up to 10 possible messages and clears each error message as it is sent. Issuing *CLS
clears all error messages in the queue.
Error Message Code
Command Error Generic -100
Invalid Separator
-103
Illegal Parameter Value -224
Invalid Unit Number -241
Queue Overflow -350
No Error -0
B.96 SYSTem:EXTernal COMMAND
SYST:EXT
Syntax: Short Form: SYST:EXT Long Form: SYSTem:EXTernal
where OFF = disable, ON = hazardous external enable, ISOLated = isolated external enable
Description: Enables or disables external analog programming. OFF disables adjustment of the controlled
parameter using an external voltage. ON enables the hazardous external input from ± REF IN. ISOL
enables the isolated external input from pins 2 and 7 of the ANALOG CONTROL connector. Refer to
PAR. 2.6.5 for details.
B.97 SYSTem:EXTernal? QUERY
SYST:EXT?
Syntax: Short Form: SYST:EXT? Long Form: SYSTem:EXTernal?
Returns: OFF (disabled) or ON (hazardous external input enabled) or ISOL (isolated external input
enabled.
Description: Indicates whether external analog programming is enabled or disabled. Refer to PAR. 2.6.5 for
details.
B.98 SYSTem:FAN COMMAND
SYST:FAN
Syntax: Short Form: SYST:FAN Long Form: SYSTem:FAN
Where = integer, either 0 or 100
Description: SYST:FAN 0 sets fan to off. SYST:FAN 100 sets fan to on.
B.99 SYSTem:FAN? QUERY
SYST:FAN?
Syntax: Short Form: SYST:FAN? Long Form: SYSTem:FAN?
Returns = 0 or 100
Description: Indicates fan status: 0 = off, 100 = on.