KEPCO EL Series Electronic Load Operator Manual P/N 243-1295 Firmware Version 4.00 to 4.xx - Manual (Page 77)

SERIES EL 071414
B-9
B.43 [SOURce:]POWer[:LEVel][:IMMediate][:AMPlitude]? QUERY 
POW?
Syntax: Short Form: [SOUR:]POW[:LEV][:IMM][:AMP]?
Long Form: [SOURce:]POWer[:LEVel][:IMMediate][:AMPlitude]?
Returns = power setpoint
Description: Indicates power setpoint.
B.44 [SOURce:]POWer:PROTection COMMAND 
POW:PROT
Syntax: Short Form: [SOUR:]POW:PROT Long Form: [SOURce:]POWer:PROTection
where = power protection setpoint
Description: Selects power protection setpoint. This is a user-defined value which, if exceeded during operation,
causes a FAULT condition, forcing the load to disengage.
B.45 [SOURce:]POWer:PROTection? QUERY 
POW:PROT?
Syntax: Short Form: [SOUR:]POW:PROT? Long Form: [SOURce:]POWer:PROTection?
Returns = power protection setpoint
Description: Indicates power protection setpoint.
B.46 [SOURce:]POWer:PROTection:STATe[:LEVel] COMMAND 
POW:PROT:STAT 0
Syntax: Short Form: [SOUR:]POW:PROT:STAT[:LEV] 0
Long Form: [SOURce:]POWer:PROTection:STATe[:LEVel] 0
Description: Clears power protection error.
B.47 [SOURce:]POWer:PROTection:STATe[:LEVel]? QUERY 
POW:PROT:STAT?
Syntax: Short Form: [SOUR:]POW:PROT:STAT[:LEV]?
Long Form: [SOURce:]POWer:PROTection:STATe[:LEVel]?
where: = 1 (power protection error occurred)
0 (power protection error has not occurred)
Description: Indicates whether a power protection error has occurred (1) or not (0).
B.48 [SOURce:]RESistance[:LEVel][:IMMediate][:AMPlitude] COMMAND 
RES
Syntax: Short Form: [SOUR:]RES[:LEV][:IMM][:AMP]
Long Form: [SOURce:]RESistance[:LEVel][:IMMediate][:AMPlitude]
Where: = resistance setpoint
Description: Establishes resistance setpoint. The resistance setpoint only affects the load when the load is in
Resistance mode of operation. Resistance setpoint is stored in non-volatile memory; value is restored
upon power-up.
B.49 [SOURce:]RESistance[:LEVel][:IMMediate][:AMPlitude]? QUERY 
RES?
Syntax: Short Form: [SOUR:]RES[:LEV][:IMM][:AMP]?
Long Form: [SOURce:]RESistance[:LEVel][:IMMediate][:AMPlitude]?
Returns: = resistance setpoint
Description: Indicates resistance setpoint.